HP P6000 Command View 10.1 on VM hosted by vSphere 5.1

磁盘存储、磁带存储、存储网络架构设备、存储软件等

Moderator: xyevolve

Forum rules
1. 本版是定位于惠普存储产品的技术讨论区。
2. 本版鼓励发帖共同讨论技术问题,不鼓励站内信件私下交流,独知知不如众知知。
3. 本版允许转贴或引用他人的作品,但必须声明原作者信息。
4. 本版禁止发表出售、求购、或其他非技术讨论等帖子。
5. 本版禁止灌水,包括但不限于任何与所讨论主题无关的回复,无意义字符,直接复制其他回复等。
6. 本站附件禁止用于商业目的,请在下载后24小时内删除,本站不对其造成的结果负任何责任。
Post Reply
SYSTEM
网站编辑
Posts: 264
Joined: Mon Feb 20, 2012 3:45 pm

HP P6000 Command View 10.1 on VM hosted by vSphere 5.1

Post by SYSTEM » Tue Oct 09, 2012 4:39 pm

Russ wrote:I am trying to configure HP P6000 Command View 10.1 on a w2k8 R2 virtual machine hosted by VMware vSphere 5.1.

I am able to install Command View but I do not see the EVA 4400’s.

The ESXi servers see the EVA’s and all the LUN’s.

The RDM SAN based disk is visible by the servers and I added “Hard disk 2 Mapped Raw LUN” to the vm that is running Command View.

Has anyone successfully configured this and if so what am I missing?

SYSTEM
网站编辑
Posts: 264
Joined: Mon Feb 20, 2012 3:45 pm

Re: HP P6000 Command View 10.1 on VM hosted by vSphere 5.1

Post by SYSTEM » Tue Oct 09, 2012 6:25 pm

Matthias wrote:
Russ wrote:I am trying to configure HP P6000 Command View 10.1 on a w2k8 R2 virtual machine hosted by VMware vSphere 5.1.

I am able to install Command View but I do not see the EVA 4400’s.

The ESXi servers see the EVA’s and all the LUN’s.

The RDM SAN based disk is visible by the servers and I added “Hard disk 2 Mapped Raw LUN” to the vm that is running Command View.

Has anyone successfully configured this and if so what am I missing?
Doesn't work with ESX unless you enable DirectPathIO and dedicate the FC HBA to the VM. That should be explained in the CV manual.
You can do this with Windows 2012 and their Synthetic Fibre Channel adaptor.

SYSTEM
网站编辑
Posts: 264
Joined: Mon Feb 20, 2012 3:45 pm

Re: HP P6000 Command View 10.1 on VM hosted by vSphere 5.1

Post by SYSTEM » Tue Oct 09, 2012 6:26 pm

Mani wrote:make sure you have completed the steps in “Configuring the VMware guest operating system for HP P6000 Command View” section of Command View installation guide

http://bizsupport1.austin.hp.com/bc/doc ... 472908.pdf - Page 41

Post Reply