HP 5200le换定影膜后报“50.3 FUSER ERROR ”是什么问题啊?

惠普喷墨打印机、激光打印机、多功能一体机、扫描仪、绘图仪等

版主: xyevolve

版面规则
1. 本版是定位于惠普打印机产品的技术讨论区。
2. 本版鼓励发帖共同讨论技术问题,不鼓励站内信件私下交流,独知知不如众知知。
3. 本版允许转贴或引用他人的作品,但必须声明原作者信息。
4. 本版禁止发表出售、求购、或其他非技术讨论等帖子。
5. 本版禁止灌水,包括但不限于任何与所讨论主题无关的回复,无意义字符,直接复制其他回复等。
6. 本站附件禁止用于商业目的,请在下载后24小时内删除,本站不对其造成的结果负任何责任。
回复
tlm1225
注册用户
帖子: 14
注册时间: 2011年 11月 3日 08:45 星期四

HP 5200le换定影膜后报“50.3 FUSER ERROR ”是什么问题啊?

帖子 tlm1225 » 2012年 5月 15日 21:38 星期二

一台5200le,打印有拖影,模糊,初步判断是定影膜的问题,于是了更换定影膜,在更换的时候还用酒精把陶瓷片和传感器和保险擦了擦;

装上后竟然开机报:“50.3 FUSER ERROR”,怀疑没装好,于是反复重新拆装了几次故障依旧,把旧膜换回去故障还是一样,各接头和排线都确定没插反或漏插,数字表测量陶瓷片是通的,保险也是通的;

曾经从其他好的5200上拆过定影组件测试过,能开机,没有出现50.3 FUSER ERROR,但是没有打印测试过,查过相关资料说是50.3是报定影温度过高,可是拆下来感觉没有热的感觉处于常温状态

真不知道是哪的问题了,求专家赐教……

SYSTEM
网站编辑
帖子: 265
注册时间: 2012年 2月 20日 15:45 星期一

Re: HP 5200le换定影膜后报“50.3 FUSER ERROR ”是什么问题啊?

帖子 SYSTEM » 2012年 5月 16日 01:39 星期三

Try to check with below info,
50.3 error or grinding noise after reinstalling the high voltage power supply (hvps)

When installing the hvps a false 50.3 error can occur if the hvps is installed on the wrong side of the mounting bracket (2 screws that hold it in place from the rear.

Be sure to mount the hvps on the side closest to you (when installing from the back side of the printer).

Also take care when reinstalling the hvps as all the contact springs have to line up with the contact points on the hvps.

A grinding noise can occur if a contact spring near the duplex drive gear gets pushed into the duplex drive gear (this is on the right side when looking from behind the printer).

回复